High Availability in the Arctic

 I returned last week from a trip to Barrow, Alaska, the Northern-most settlement in North America.  Many people read my daily posts (http://blog.timrettig.com/category/barrow/), and have been asking me exactly what I installed while I was there.  So in this post I will go into more detail about the software I setup. 

My primary purpose for trip was to install a high-availability server cluster running Avance from Stratus Technologieshttp://www.stratus.com/products/avance/index.htm.  I installed the solution in July when the weather is in the 40s, and the sun shines around the clock.  The platform I installed is so dependable that no one should need to visit the site again for a long time.  And hopefully no one has to go back in the winter, when the weather can be 50 below and the sun doesn’t come up for months. 

To guarantee the uptime we needed, we chose the Avance software in order to have a cost-effective high availability virtual cluster.  The solution is so fault tolerant, an entire physical server can fail, and the virtual machines that were running on the failed server will start right back up on the surviving node.  It truly separates the running virtual machines from the hardware.  Avance monitors the health of the system, all the way down to the status of fans and hard drives.  If anything on a node fails, it will automatically migrate the virtual machines off of it and send out a notification.

Avance Arctic Configuration
Avance Arctic Configuration

 The Avance software is loaded on two physical servers.  That creates a single logical platform to run virtual servers across.  Data is continuously replicated between the two nodes.  Because of the replication, it doesn’t require a SAN.  That not only saves money, but it also reduces Continue reading “High Availability in the Arctic”